Title Bldg Technology Sample Exam.doc ✅

___________43- IS THE TERM GIVEN WHERE A CIRCULAR CONCRETE CORE IN ENCLOSED BY SPIRALS WITH VERTICAL OR LONGITUDINAL BARS. ___________44- WHERE STRUCTURAL STEEL COLUMN IS EMBEDDED INTO THE CONCRETE CORE OF A SPIRAL COLUMN. __________45- WITH STRUCTURAL STEEL COLUMN ENCASED IN CONCRETE OF AT LEAST 7 CM. THK. REINFORCED WITH WIRE MESS SURROUNDING COLUMN AT A DISTANCE OF 3 CM. INSIDE THE OUTER SURFACE OF THE CONCRETE COVERING. ___________46- IS A FABRICATED STEEL PIPE PROVIDED WITH A FLAT STEEL BARS OR PLATE WHICH HOLD A GRIDDER, GIRTS OR BEAM. THE STEEL PIPE IS SOMETIMES FILLED WITH GROUT OR CONCRETE FOR CORROSION. METAL REINFORCEMENT ___________47- IS A COMBINATION OF CONCRETE AND STEEL. ___________48- IS STRONG IN SUPPORTING COMPRESSION LOAD BUT WEAK RESISTING TENSION FORCES. ___________49- POSSESSES THE STRENGTH TO RESIST BOTH COMPRESSION AND TENSION. ___________50-WHEN THE AREA OF THE CONCRETE AND STEEL ARE JUST ENOUGH TO CARRY THE COMPRESSION AND TENSION FORCES SIMULTANEOUSLY. ___________51-REFER TO THE PORTION OF A BEAM WHERE BENDING MOMENT CHANGES FROM POSITIVE TO NEGATIVE. ___________52-WHEN THE BARS ARE NOT BENT, AN ADDITIONAL STRAIGHT REINFORCING BARS ARE PLACED ON THE TOP OF THE BEAM ACROSS THE SUPPORTS EXTENDED TO THE REQUIRED LENGTH. __________-53 ARE BENT UP ON OR NEAR THE INFLECTION POINT AND ARE EXTENDED AT THE TOP OF THE BEAM ACROSS THE SUPPORT TOWARDS THE ADJACENT SPAN. __________-54 ALLOWANCE PROTECTIVE COVERING OF STEEL BARS FROM THE OUTSIDE OF THE REINFORCEMENT. WOOD STRUCTURE ___________55- A SHORT FLAT PIECE OF LUMBER WHICH IS BOLTED, NAILED OR SCREWED TO TWO BUTTING PIECES IN ORDER TO SPLICE THEM TOGETHER. ___________56- A WOOD OR METAL PIECE USED TO FASTEN TOGETHER THE ENDS OF TWO MEMBERS WITH NAILS OR BOLTS. ___________57-A METAL PLATE USED FOR FASTENING TWO OR MORE MEMBER TOGETHER ___________58-A CARPENTRY JOINT BY TWO UNEVEN TIMBERS, EACH OF WHICH NOTCHED AT THE PLACE WHERE THEY MEET. ___________59- JOINING OF TIMBERS, USUALLY MEETING OR CROSSING AT RIGHT ANGLES, BY CUTTING A DAP IN ONE OR BOTH PIECES. ___________60- A JOINT CONNECTING TWO WOOD MEMBERS WHICH CROSS EACH OTHER, HALF THE THICKNESS OF EACH IS CUT SO THAT THE THICKNESS WILL THE SAME AS THAT OF EACH MEMBER. ___________61- A TYPE OF HALF LAPPED USED TO RESIST TENSION ___________62- A JOINT IN WHICH TWO TONGUES PROJECT FROM THE SIDES OF THE TENONED MEMBER, THESE TONGUES FIT INTO CORRESPONDING \SLOTS IN THE MORTISED MEMBER.